Difference between revisions of "IoTuz Dev Environment"

From Open Hardware Miniconf
Jump to: navigation, search
Line 5: Line 5:
 
Instructions for installing the ESP-IDF dev framework are at https://github.com/espressif/esp-idf#setting-up-esp-idf
 
Instructions for installing the ESP-IDF dev framework are at https://github.com/espressif/esp-idf#setting-up-esp-idf
  
Before the '''Open Hardware MiniConf''', it's recommended that you complete steps ''1-3'' of the specific setup guides for your OS.
+
Before the '''Open Hardware MiniConf''', it's recommended that you complete steps '''''1-3''''' of the specific setup guides for your OS.
  
 
=USB Serial Drivers=
 
=USB Serial Drivers=

Revision as of 09:50, 9 January 2017

The IoTuz uses the ESP32 at its core, and hence the dev environment for the IoTuz is the standard ESP_IDF dev environment/framework.

Installing the Dev Framework

Instructions for installing the ESP-IDF dev framework are at https://github.com/espressif/esp-idf#setting-up-esp-idf

Before the Open Hardware MiniConf, it's recommended that you complete steps 1-3 of the specific setup guides for your OS.

USB Serial Drivers

The on-board USB Serial chip for the IoTuz is the CP2102, and you'll need support for this to communicate with the board. You can download drivers from http://www.silabs.com/products/mcu/pages/usbtouartbridgevcpdrivers.aspx if required.

If you have a Linux 3.x or later kernel, these drivers are usually supplied by default with the OS Distro. If you roll your own kernel or are using a really stripped down system, you may need to build them from source.