IoTuz Dev Environment: Difference between revisions

Latest revision as of 08:56, 16 January 2017

The instructions for installing the IoTuz Dev Environment are now on Github at: https://github.com/CCHS-Melbourne/IoTuz/wiki/Software-Instructions

Note: These instructions were changed just before the OHC2017 so if you haven't updated your install, please check them again.

@@ Line 1: / Line 1: @@
-The IoTuz uses the ESP32 at its core, and hence the dev environment for the IoTuz is the standard ESP_IDF dev environment/framework.
+The instructions for installing the IoTuz Dev Environment are now on Github at: https://github.com/CCHS-Melbourne/IoTuz/wiki/Software-Instructions
-=Installing the Dev Framework=
+Note: These instructions were changed just before the [[OHC2017]] so if you haven't updated your install, please check them again.
-Instructions for installing the ESP-IDF dev framework are at https://github.com/espressif/esp-idf#setting-up-esp-idf
-Before the '''Open Hardware MiniConf''', it's recommended that you complete steps '''''1-3''''' of the specific setup guides for your OS.
-=USB Serial Drivers=
-The on-board USB Serial chip for the IoTuz is the CP2102, and you'll need support for this to communicate with the board. You can download drivers from http://www.silabs.com/products/mcu/pages/usbtouartbridgevcpdrivers.aspx if required.
-If you have a Linux 3.x or later kernel, these drivers are usually supplied by default with the OS Distro. If you roll your own kernel or are using a really stripped down system, you may need to build them from source.